Plot Problem
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2006-09-11
03:30 AM
- last edited on
2023-05-25
06:23 PM
by
Rubia Torres
2006-09-11
03:30 AM
Im using the OS X version of AC 10 student.
3 REPLIES 3

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2006-09-11 05:31 PM
2006-09-11
05:31 PM
slothdog wrote:Not answering your question, but asking another one: did you try printing? What are your user rights on the computer? Maybe you are not allowed to install/modify printers?
I posted this in the hardware forum, but maybe i should post here too since it is the student version that im using (10). I cant get the plotter part to find my designjet 2500cp over the network. I type in its ip and it doesnt find it or do anything with it. Is there any info available on how to get this to work?
Im using the OS X version of AC 10 student.
Djordje
ArchiCAD since 4.55 ... 1995
HP Omen
ArchiCAD since 4.55 ... 1995
HP Omen
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2006-09-11 06:22 PM
2006-09-11
06:22 PM
Djordje wrote:slothdog wrote:Not answering your question, but asking another one: did you try printing? What are your user rights on the computer? Maybe you are not allowed to install/modify printers?
I posted this in the hardware forum, but maybe i should post here too since it is the student version that im using (10). I cant get the plotter part to find my designjet 2500cp over the network. I type in its ip and it doesnt find it or do anything with it. Is there any info available on how to get this to work?
Im using the OS X version of AC 10 student.
yea, i tried printing, nothing happened.
im the only user on the network with the only computer (a powerbook g4).
i have 2 networked printers (one plotter, one regular) both connected to a router and they work fine outside of archicad.
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2006-09-11 06:42 PM
2006-09-11
06:42 PM
so after alot of pain i found which port the plotter is on and then when i pick plot from the menu it sends it, but it never prints. however, if i go to regular printing and select the plotter from the printers it worked (which supprised me). how come it works like this but not from the plot option?