Boolean operation with poser model

[Anonymous]

Any suggestion, how to get poser model (hand) work in boolean operation?
Model itself imported fine to AC and it looks ok, but when I try to cut a part of the wall with it, nothing happens.
Or any idea or another way to make hands' mark in concrete (by modelling it)?

[Dwight]

The command is WALLNICHE or CUTFORM. Are these new in ArchiCAD 10?


I'm thinking that our poster needs to replicate a hand with thin slabs to form a contour of the hand - a flapjack hand - and tilt it upward when saving as an object, using the object to SEO the wall.

But good luck getting this amount of definition:

[Link]

Right - that's what I meant. Save part of the body as a part. Then save the part with a 'wallniche' ID as a window/niche. Then whack it into the wall.

It should have the same geometry as the original part, but I am probably just dreaming that it would work.

Cheers,
Link.