Fillet morph

[Anonymous]

I am trying to fillet two edges of a morph that merge into a corner. I can only fillet one of the edges if I try to fillet the other a pop up dialogue says, radio too large... you can fillet the edge.
Any answers?

[DGSketcher]

See if this helps...

https://helpcenter.graphisoft.com/guides/archicad-22/archicad-22-reference-guide/elements-of-the-vir...

[Barry Kelly]

You must select both edges at the same time, then fillet and apply to all edges.

Barry.

[Anonymous]

How can I select both edges at the same time. It seems imposible to me.

[Barry Kelly]

The same as you do for other elements, by holding the SHIFT key to add or subtract from your selection set.
But because you are talking about individual edges of a morph, you must make sure that the selection tool is in sub-element mode.
Or use CTRL+SHIFT to temporarily enter sub-element selection mode.
The CTRL key toggles this mode on while you hold it.

Barry.