Get retaining walls below 0'0" level to show up on site plan

[Gus]

Does anyone have a clue about how I can get retaining walls below 0'0" level to show up on the site plan which is on my 1st story level? They are currently "associated' with the 1st level as being on that level (even though they are below 0'0". I have also set them to "all relevant stories" and that doesn't seem to change anything. How do I get them to show up when they are below 0'-0"?

[Anonymous]

Try Symbollic Cut or Outlines Only in floor plan display.

[Gus]

View Settings, Floor Plan Cut Plane Settings. Then adjust as needed.

[Anonymous]

Gus wrote:
View Settings, Floor Plan Cut Plane Settings. Then adjust as needed.

You cannot have a negative FPCP.

[Gus]

You chose to "show down to" then chose "project zero"