HEELP!! custom curved ramp

[Anonymous]

has anyone ever created a custom curved ramp in the history of archicad?? it would be the achievement of the century if i could do it just once for an important project i'm working on.

i know archicad has a curved ramp tool but it only lets you follow a circular path not a custom one.

of course you can create a custom curved path as i have done using spline and then slab or mesh tool but this is not a ramp until one end is higher than the other.

I basically want this ramp to go from say 0 - 6 metres high at a uniform gradient.

i have tried objective (much of my hair was pulled out trying to get it to do what i wanted) but my conclusion is that the 'regular profile' does not, will not and never has any intention of following a 'defined' path you give it... only the path that regular profile wants to follow.

i could raise every randomly spaced mesh point individually calculating how high to raise each point each time... this would take 78,000 light years and i have only 2 days to figure it out.

any help is greatly greatly appreciated!!

[adzik]

Just add the unpacked folder into your current project using the Library manager and it should work.

[Anonymous]

I finally got it! I had to double click in winrar. Then extract the subfolders.
Thanks again!