Interior Wizard - custom profiles/mouldings?
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-12-06 05:18 PM
2005-12-06
05:18 PM
Is there a way to add to the list of available mouldings/profiles in the interior wizard?
Ideally I'd like to draw profile of my choosing, set a logical insertion point, and have it available in the pull-down list. Saving such a drawing as a gdl macro or something would be fine.
The crown and base selection is quite limited, and its only a mater of time before someone wants to see a profile that's not in the list.
And yes of course I could use the profiler, or Neil's smartparts, but the wizard seems so...magical.
thanks.
Nathan
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2005-12-06 05:38 PM
2005-12-06
05:38 PM
Nathan wrote:As wonderful as it would be, the profiles are hard-coded into the accessory objects and do not allow for custom additions. The Archicad Profiler kind of does this, but is painful to edit.
Hi folks,
Is there a way to add to the list of available mouldings/profiles in the interior wizard?
Ideally I'd like to draw profile of my choosing, set a logical insertion point, and have it available in the pull-down list. Saving such a drawing as a gdl macro or something would be fine.
The crown and base selection is quite limited, and its only a mater of time before someone wants to see a profile that's not in the list.
And yes of course I could use the profiler, or Neil's smartparts, but the wizard seems so...magical.
thanks.
Nathan
There are a couple add-ons you can buy for similar functions, such as CADImage Profiler and the Smart Parts Trim package, but even they do not act the same as an accessory.
Tom Waltz