Trying to use the material hatch to make the joints in elevations on CMU (concrete block) masonry walls in a building with non-orthogonal (and therefore off-grid) walls, the first problem I find is that the hatch seems to have a single origin for all walls and therefore cannot be adjusted to each off-grid wall.
Because the walls are non-orthogonal and are not always parallel to the section/elevation line, a fill won't do the job either. The model is rather complicated and using 2D lines all over the elevations with walls in any possible angle relative to the section/elevation plane would suck considerably.
I am thinking of attempting a window object to draw the CMUs as 3D lines on the walls. Is there a better way?
