- last edited on by
Rubia Torres
I am using the Mouldings and panels wall accessory fairly successfully to produce walls with a "wainscot. The accessory I am using has been modified slightly based on the Thread here
(While I am still avoiding the SE Library I wonder if this was fixed.)
I have a problem when using the Mouldings and Panels with W Slanted Fix Window. The window is called the " !!! W Slanted Fix 81 USA !!! " in the window objects Master Script. The wall hole for this window is a large Rectangular hole. See attached.[/img]
A Solution is to give the "background" wall the same material specification as the upper wainscot. See Attachment
The materials do not "line-up" though.
This is not a solution if the break in the Wainscot happen halfway or so up the window.
The materials do not "line-up" though.
This is not a solution if the break in the Wainscot happen halfway or so up the window.
Here is the Actual Section Elevation view with the material I am using.
Not too bad. But still would not be good if the wainscot started somewhere within the window height.
Not too bad. But still would not be good if the wainscot started somewhere within the window height.
Still looking?
