- last edited on by
Rubia Torres
1. I have to model a roof with polygonal edges. I modeled the underside of the roof with the mesh tool.
If I use the mesh-to-roof tool, I will get a roof with the upperside in the underside position and is not ok.
I tried with the 3D approach. I modeled the roof in 3D but the same problem appears.
Is it possible to modify the reference plane of a roof?
2. How can I draw a roof with more than 90 degrees slope. That is, inverted.
I want the underside of the roof to be in the actual position of the mesh. Everything I've tried does the opposite: it generates an inverted roof whose planar projection is ok but the materials are on the other side. So I can't calculate room clearance on the inside of the building correctly.
I have to use the mesh, because the roof is very irregular. A solution could be to remodel the mesh in the position of the upperside of the roof and then generate the roof.
I don't know about the slanted wall method. I know only the position of the mesh in 3D. How can I model all the walls in the correct position?
And, yes, the solution with changed composites seems the correct approach.
Still remains the problem of generating the roof first.
I have to use the mesh, because the roof is very irregular. A solution could be to remodel the mesh in the position of the upperside of the roof and then generate the roof.
I don't know about the slanted wall method. I know only the position of the mesh in 3D. How can I model all the walls in the correct position?
And, yes, the solution with changed composites seems the correct approach.
Still remains the problem of generating the roof first.
Still looking?
