Stair Maker

[GFBArchitect]

I hate the thing in stairmaker that keeps trying to make the ratio of rise to run fall in a certain ratio and then give error messages. Since that ratio is no longer in the code it isn't needed. Can this be eliminated or bypassed?

Thank you!

[Laszlo Nagy]

In such a case I would just set the minimum and maximum values for the (2*Riser)+Tread fields to low enough and high enough values so even if those values change they do not give an error message.
As I see, 200 is the minimum you can set, but there is no practical upper maximum.

[GFBArchitect]

Thanks, You're right, I was just too impatient and didn't notice the variable settings.