Stair problem again!! And again!!

[Anonymous]

Heeeeelp!!!
I cannot build this stair, can anyone tell me why ???

Thank you!

[Anonymous]

You don't give enough info to be sure. It would help to post the settings dialog with the parameters shown.

One possibility is that there is not enough setback/return at the landings (or winders as the case may be). The stair tool can't align the end of one winder tread directly over the end of the one below.

[Anonymous]

It doesnt show any other window than that.
But I think you are right there is not enough space.
Ill try again

[Anonymous]

i get your stair . . . but there is a little hidden trick
anyway archicad stairs are terrible !

[Anonymous]

Heyyy!!!
How did you do that?
Although, I think that the lengths in your stair are bigger.
I post another image with dimensions, I think that the problem is where the treads turn, or not ?

[Anonymous]

And in inches

[Anonymous]

i was not able to create your stair i was limited to structure of stairs...check pic down

[Anonymous]

i was not able to create your stair in archicad stairs . . .
I think that you will have to model them manualy.

i could only create them with these kind of structure . . .

[Anonymous]

Yes!!!
Thank you very much!!