Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Trim to roof anomoly

Anonymous
Not applicable
I've got a roof with valleys and when I trim the walls below to the two roofs forming the valley I get this little skinny piece of wall sticking up right through the valley. Anyone else had this problem and know how to fix it?

Rick
22 REPLIES 22
Anonymous
Not applicable
Peter wrote:
Karl wrote:
Did 'miter' work in earlier versions of AC with dissimilar sloped roofs? Wonder if this is a bug or user error on my part.
Vertical mitre worked in AC10, but not in 11 or 12!

It worked in AC10 with unequal thickness's too.
How do you get the moulding around the edge of your roof like that? Are you using a complex profile somehow?
Djordje
Ace
Wrathchild wrote:
Peter wrote:
Karl wrote:
Did 'miter' work in earlier versions of AC with dissimilar sloped roofs? Wonder if this is a bug or user error on my part.
Vertical mitre worked in AC10, but not in 11 or 12!

It worked in AC10 with unequal thickness's too.
How do you get the moulding around the edge of your roof like that? Are you using a complex profile somehow?
Complex profile beams?
Djordje



ArchiCAD since 4.55 ... 1995
HP Omen
Anonymous
Not applicable
Wrathchild wrote:
Peter wrote:
Vertical mitre worked in AC10, but not in 11 or 12!

It worked in AC10 with unequal thickness's too.
How do you get the moulding around the edge of your roof like that? Are you using a complex profile somehow?
It's just a section through the default roof composite. No moulding involved!

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!