Walls not joining properly

[Anonymous]

Ok, this is a bit of a mystery to me: both walls are the same (type, height, layer, etc), their reference lines meet (I turned them on for reference), wall skin priorities are okay (10 for studs, 8 for drywall), and yet the drywall on the exterior face is interrupted. Am I missing something? Is this yet another corrupted file? Anything else I might've forgotten to check?

[Thomas Holm]

Try using the intersect command. Turn on all layers, check with Show all in 3d that there isn't anything that interferes (maybe from another story).

[__archiben]

Sergio wrote:
Is this yet another corrupted file? Anything else I might've forgotten to check?

if the wall skin priorities are correct in the composite's dialogue, check that they haven't been manually over-ridden in that wall's specific settings . . . :

~/archiben

[Anonymous]

~/archiben wrote:
if the wall skin priorities are correct in the composite's dialogue, check that they haven't been manually over-ridden in that wall's specific settings . . . :

Thanks guys for the help. Apparently this was the problem on some of the walls (not all). Don't know how that happened - I'll need to check my wall defaults. So, up and running again. Thanks again.