Barrel Vaulted Roof
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-06-22 08:23 PM - last edited on ‎2023-05-11 03:57 PM by Noemi Balogh
‎2007-06-22
08:23 PM
When I use the barrel vault roof tool, it creates a curved roof in 3 sections. So it doesnt look curved at all.
Is there a way to change the amount of segments that ArchiCAD will create for a curved roof?
Thank you.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-06-22 08:46 PM
‎2007-06-22
08:46 PM
Adjust Magic Wand tolerance to suit.
Dwight Atkinson
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-06-23 02:10 PM
‎2007-06-23
02:10 PM
todjen:
Some users are using the Beam tool with a Custom Profile of the curve to create these sorts of roofs. They are true curves, not segmented. You can search the forum for more information.
David
Some users are using the Beam tool with a Custom Profile of the curve to create these sorts of roofs. They are true curves, not segmented. You can search the forum for more information.
David
David Maudlin / Architect
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14