About Krispaco

Krispaco · 2026-03-18

I'm wondering is there a way to generate autotext and be able to copy or convert the contents to regular text from it? For example, I have created a text/autotext label that I can use to quickly generate and document a detail drawing, but in some of those labels I would like...

Krispaco · 2026-03-03

When editing the skin list label, there is an option to toggle text wrapping, however I can't seem to be able to reduce the size of the label. Or does the text wrapping option apply to the head text only?Sometimes the skin list contains a material that has a longer descripti...

Krispaco · 2026-03-02

Hello. I've ran into a possible problem when dealing with splitting a schedule to multiple layouts. If I want to add any additional information on only one of those split pages, it copies the same information on the other layout at the exact same location (e.g. adding text)....

Krispaco · 2025-11-13

I'm encountering a problem, where if I lay two complex profile walls on top of each other, and use vertical offset modifiers to change sheathing/insulation height on both, it creates a protruding corner on the bottom wall. I could not use a complex profile on the top wall an...

Krispaco · 2025-05-30

Hello. I recognize that this question should be addressed directly to CI as it is their product, but I'm sure a lot of people use it here as well.I'm having a problem with using horizontal trims on my wall coverings. I'd like it to extend over the cladding by a small margin,...

Krispaco · 2026-03-18

Thanks. That was exactly what I was looking for. Works perfectly in my case, because I'm not trying to change anything globally, just expanding some information in a detail drawing. This way I can quickly generate labels with building material autotext and edit them where I ...

Krispaco · 2026-03-10

Picture for attention, what I'm trying to do. Or is this not possible?

Krispaco · 2026-03-03

I'm fine with manually placing the schedule on multiple layouts if I have to. I would just like to understand if you cannot place elements / text only on a single layout of the split drawings.

Krispaco · 2025-03-24

Managed to figure it out.Made a few more skin list labels, all of which had the option available to change. Figured out I had custom content checkbox ticked, which makes it not possible to change the order.

Krispaco · 2025-03-18

Managed to find the issue after a couple of days of struggling. By slowly pushing the garage door further from the outer wall face to the inner, found the point the color changes, and then realized it was a zone with a clear glass model surface. So is the solution to create ...

User Statistics

User activity

Edit or copy autotext content

Skin list text length / wrapping

Split schedule / adding information on each page seperately?

Complex wall with offset modifiers intersection issue.

CI Tools Horizontal trim not extending beyond wall surface

Re: Edit or copy autotext content

Re: Skin list text length / wrapping

Re: Split schedule / adding information on each page seperately?

Re: AC27 Skin list label text order

Re: 2D Garage door Color not showing.