Does anyone know if there is a way to lock the horizontal and vertical
boundaries inside the section elevation? When I'm working close to the
edges (inside the section elevation) normally when trying to lay the
dimensions, I often pick up the vertical or horizontal boundarie...
Do you know of a way to create: Auto-text that reads the sheet size in
layout space, eg. A1, I know it can be done through index setting,
however I want to see this displayed as A1 etc not the actual size. See
example below..
Yes, you are right, Horizontal Range is what you were talking about not
"Horizontal Boundaries". Your ArchiCAD knowledge never ceases to impress
me.Thanks again for the solution. 
Thank you muchly Turning off the Elevation Range from within the
elevation was definitely the answer   However, you mentioned,"The
horizontal limited range can only be seen in the floor plan view (or the
settings)." Yet, I can see and adjust from inside the section elevatio...
Hiya, Lingwisyer.Thanks for your question,Firstly,1. On the cover page
is an index that reads all sheet numbers and sheet names.2. I can add
sheet size, however this does not display as A1 A2 etc, it gives the
size in millimeters see example 420/297. I would like this to rea...
This is just the same as typing in the size on the Master layout Title
block, (except my naming convention for the master layouts would be more
restricted).And if I change the master layout size (for any reason) then
I would have to change the name too A good suggestion but ...
