Hi. I use Roof Accessories for the roof, but if I have a roof with a
different degree of slope, the sheet metal does not connect at one
point. Please take a look at the screen.Please advise how I can adjust
it?
Hi there.I am choosing a laptop for work. I have read the system
requirements on the Graphisoft website:
https://Graphisoft.com/resources-and-support/system-requirements , but I
am wondering about the screen size. Sometimes I will work on this laptop...
Hi CubaIf you pull out one side of the roof (the one where the starting
point was) to edit the roof, everything will break. I know we can move
and adjust the lines, but I have a very complicated roof and I can't
move it. My question was mainly about ...
This means that there is no chance to model a roof in the shape I am
attaching and have a similar position of the sheet metal.This tool
cannot be controlled, It makes no sense.
I noticed that the problem was at the starting point of roof modeling.
Because when I create one roof and then divide it into two slopes with
different angles, it's OK, but when I only cut off or stretched a piece
where there was a starting point, ev...
