About Aiden

Aiden · 2022-10-19

Hi. Hopefully a quick an easy one. When I use offset edge and wish to align to the midpoint of another element, the snap point along that element doesn't appear. Snap points are switched on and when I go to draw a polyline from that midpoint there is no issue, only when I am...

Aiden · 2022-06-17

Seeing some unexpected behaviour in the 3D window. When I orbit (Shift+MMB) in perspective projection, AC orbits around a point near to the centre of the selected geometry. In parallel projection, however, AC orbits around a point near to the centre of the entire model regar...

Aiden · 2022-05-22

Hi there,I have two plan views from the same storey, one is an overall view (let's say GA) and the other is a detail view (not an AC detail, but a detailed storey view) at at finer scale. There is a detail marker on the storey that links to the view of the plan detail, which...

Aiden · 2022-03-31

Hi, apologies if this has already been answered. In Archicad 23, when I edit a curtain wall which has been created using the plane input method and boundary and has had its scheme grids modified through the curtain wall edit mode, when the boundary is changed through the cur...

Aiden · 2022-10-24

Thanks Barry, thanks Mahmoud. I think that's a good solution.

Aiden · 2022-05-23

Thanks Barry, that is looking like the best solution. Another solution which I found in some cases was to crop the view on the layout so that the marker is cropped outside the bounds of drawing. If you were going to be pendantic then I guess the marker extent should match th...

User Statistics

User activity

Snap points don't appear when using offset edge.

Orbit - Not Using Centrepoint of Selected Geometry

Prevent Detail Marker from Referencing Itself

Curtain Wall Scheme Grid Reverts to Original Grid Pattern When Boundary is Edited

Re: Snap points don't appear when using offset edge.

Re: Prevent Detail Marker from Referencing Itself