Can someone explain to me how I can edit the corner of a stud created as a complex profile using offset modifiers?  

Some of my layouts in my publisher sets are not publishing. It says it published but when I go to the folder it will not show in the folder.

I used the morphs options to create a custom wall of stud framing and plywood so I could edit the wall more in depth. I plan to add more layers to the walls later, but I am trying to figure out if there is a way to save this as a complex profile to b...

how do you trim the tops an bottoms of walls? for instance, I want these two walls to meet at a 75 degree angle