License Delivery maintenance is expected to occur on Saturday, November 30, between 8 AM and 11 AM CET. This may cause a short 3-hours outage in which license-related tasks: license key upload, download, update, SSA validation, access to the license pool and Graphisoft ID authentication may not function properly. We apologize for any inconvenience.
Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.
I am doing that in a zone stamp... It is taking the area and dividing by the occupant load. Then you can use a schedule and add all the loads per zone together. There is a zone in the depository that does this also.
You can edit the zone stamp to fix this. Whever the calculation is being made for the occupants there is probably the use of the INT function which will take only the whole interger for the occupant load. For example if the claculation works out to 10.234 occupants, INT will return 10. It you replace the INT function with CEIL it will return 11.
Try this instead: occLoad = STR (CEIL(net_area_val/SqFtPerson),1,0)
I'm not sure why the .5 was being subtracted from the calculation, but that was changing the value from 16.27 (which with the CEIL would return 17) to 15.77 (which with the CEIL would return 16)
was this tag ever perfected? if so can you share? I need the same type of tag and haven't learned GDL yet... still early in the move from Revit and Adesk.
