The Gravity Tool/Level Dimension Tool only works for Roof, Shell, Slab,
and Mesh. So what if you want to display the elevation of a sloped beam
on each end? You can't do it. There is not even a Label that is useful
for showing T.O.B. or B.O.B at both...
I used this function a lot in the with layers management. For example
when I want to designate a layer for everything I have selected. I don't
see it any more in ArchiCAD 25 where it used to be. Is it gone or just
in a different place?
Navisworks add-on makes it possible to save a 3d ArchiCAD model as a
*.nwc file which can be viewed in Navisworks, but apparently not as a
*.nwd that so it can be seen with the free Navisworks Freedom viewer. So
is seems that we would still need Navi...
This is not a useful answer perhaps, but the version/evolution of
Param-O we have in 25 is really just a work-in-progress. It is there for
us to fool around with but it is not entirely "ready for market" so to
speak. I think they included it in the p...
Yes. - but how does the frame width get set to 0" ? I think there might
be some way this anomaly can happen that is unintended. When you change
the Wall Closure type from Stud Wall to Solid Wall or Custom Closure you
will lose a lot of the settings y...
I have been fooling around with the door in in 25 ( D1 Commercial 25 )
and managed to get the same result as you, however, I am not sure how to
generate the anomaly again. It's complicated but I have done it more
than once. This is part of it -- How ...
Most of the work I do is for new homes. I already know from
conversations with the clients/builders and the forms I have them fill
out what the common/controlling wall heights are going to be. Its based
on cost, not any aesthetic or spatial considera...