DWG translator that worked until V28 broke in V29

[Rastko Pecar]

I built a translator for DWG export in V27 that workend flawlessly in V28 too, but in V29 it brakes. It exports the geometry all right but I get 50+ layers instead of 10 as they are set in translator settings.

Is anyone experiencig the same issues?

thanks

Operating system used: Windows 29.1 (3100)

[Laszlo Nagy]

Can you post screenshots that show all the Layer-related settings, like the Method, Pen-based layer names, and Layer name conversion pages under Settings > Attributes > Layers in the DXF-DWG Translation Setup Dialog?