Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

Empty DWG when opening with AC23

Not applicable

I have a problem with opening any dwg in AC23 (commercial version). They are totally empty. But when I open the same file with AC22 (edu version) it is all right.
In this way I am not able to work with the AC23 version
Does anyone know a solution?

Brett Brown
Place the DWG as a drawing and then explode it
Imac, Big Sur AC 20 NZ, AC 25 Solo UKI,
Barry Kelly
Try Changing your Renovation Filter to one that "Shows All".
I believe there is an issue where the DWG is set as "New" and it may not be showing in your current reno filter.

One of the forum moderators.
Versions 6.5 to 27
Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10
Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
Not applicable
Thank you for all the thips! Renovation filter was a good idea, I did not check it before but it didn't tunr to be the solution.

Placing it as a drawing and exploding it actually worked.

Thanks a lot!!!

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!