Collaboration with other software
About model and data exchange with 3rd party solutions: Revit, Solibri, dRofus, Bluebeam, structural analysis solutions, and IFC, BCF and DXF/DWG-based exchange, etc.

v19 : establish + tally average grade

Anonymous
Not applicable
Hello -

I need to verify allowable building height (aka Average Building Elevation, or ABE) on a proposed single family residence. In addition to the standard "average by four midpoints of overall rectangle" method, we want to use a second method to evaluate : the "midpoint of each wall length" method. This means I will need to keep a tally of more than 30 midpoints, and they could change if the footprint is adjusted in future design iterations. I am accustomed to an old method (dropping a hotspot at the midpoint of the wall length, striking a perpendicular line to two contours on either side of the hotspot/midpoint in question), but surely there is a way to identify and total this information.

Is there a more evolved way to find and tally this info? I'm new to v19, fwiw.
0 REPLIES 0

Start a new conversation!

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!