2020-11-0609:34 PM - last edited on 2023-05-2407:20 PM by Rubia Torres
Archicad 24 on an Imac 2020 but I've had this problem occasionally in the past as well. I made a morph, then attempted to "tip it up" 90˚. I did something where after I select to rotate, when I attempt the click on the face (with the protractor) to rotate it around that face it will only select the face that is directly beyond the face I am pointing at. How do I undo this? It makes working with morphs almost impossible.
Clint
ArchiCad 27 | Mac Studio 2023 w/ 27" mac monitor | M2 Ultra | 64 GB | Sonoma 14.2.1 | Indiana
One of the forum moderators. Versions 6.5 to 27 Dell XPS- i7-6700 @ 3.4Ghz, 16GB ram, GeForce GTX 960 (2GB), Windows 10 Lenovo Thinkpad - i7-1270P 2.20 GHz, 32GB RAM, Nvidia T550, Windows 11
