I have had a similar problem printing from ArchiCadd 11. after recently
upgraded my computer to a new iMac (iMac 11,3 model). My last computer,
an older iMac, ran OS X 10.5.8, the new one is on OS X 10.6.7. Archicad
opens and runs on the new computer, but it does not print (it prints
blanks, even though it goes through the printing dialogue) . The same
problem when I try to save drawings in pdf format. My old computer still
prints the same files fine. But I discovered one other thing: If I try to print the entire file, it works fine.
It only blanks out when I call to print "Current Zoom Only". I can still print if I run the program on the old computer
Have you seen this problem before?
Is there a solution?