Beam centerlines/hidden detail
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2011-06-07
06:03 PM
- last edited on
2023-05-30
12:28 PM
by
Rubia Torres
2011-06-07
06:03 PM
I am producing Structural steelwork documentation in ArchiCAD, when I produce elevation and sections I want to be able see beam centerlines for things such as truss verticals/diagonals and diagonal braces, as of yet I cannot find a way other than drawing them on manually (not preferred).
I also would like to show hidden detail on a PFC for example. In section you can clearly see which way a PFC is orientated but when you take a elevation on that PFC you cannot see which way the toes/back of the PFC are orientated.
Any assistance would be very much appreciated.
0 REPLIES 0