Viewport Double Update

[toman311]

I don't know why ArchiCAD is doing this, but every time I open up a sheet the viewports go through the update process twice. It really takes up a lot of time too on some sheets.

Does anybody know why this is and how I can stop it?

[Lingwisyer]

I set most of my views to manual update. Means that you need to check every view prior to publishing, but it also means that each time you make a small change, you do not get every view updating even if the change is not actually visible.



Ling.

[toman311]

Thanks for the reply.

I think I might miss something and create a mistake if I did that. I'd rather wait then make a mistake.

Thanks for the tip, but I don't think that would work for me.

[Lingwisyer]

toman311 wrote:
I think I might miss something and create a mistake if I did that. I'd rather wait then make a mistake.

Before publishing, you can always go to the drawing manager and update all of the internal drawings. You should not miss updating any this way.



Ling.

[ahmad525]

hey

was this issue fixed at all or have you found any solution ?

im having the same issue with AC25. 

its annoying and makes everything slow and sometime it takes up to 1-2 minutes till you be able to do any changes or view.