Bar joists in archicad
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-02-15 04:02 PM
2010-02-15
04:02 PM
thanks
2 REPLIES 2
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-02-15 04:16 PM
2010-02-15
04:16 PM
You say you can figure out how but don't tell us what method nor type of bar joist you are using. The beam tool slopes easily but only does a continuous profile. Library parts typically have parameters for slope (but not always, depends on the author). With the truss tool the slope is however you draw it.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-02-16 03:04 PM
2010-02-16
03:04 PM
cadmaster:
Have you looked at the object Bar Joist 13? It has an angle option with its other parameters.
David
Have you looked at the object Bar Joist 13? It has an angle option with its other parameters.
David
David Maudlin / Architect
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14
www.davidmaudlin.com
Digital Architecture
AC28 USA • Mac mini M4 Pro OSX15 | 64 gb ram • MacBook Pro M3 Pro | 36 gb ram OSX14