Fit In Window command

[Bling Keeta]

My Fit In Window command all of a sudden zooms out my window to
0.000000%. No matter how I try to tweet it, it goes to 0%. I have to use Zoom to Home to adjust my zoom. All other AC functions work with no problem.
Is there anything I can do to set this back?

[Bruce]

Does it do this on every file, or just a specific file / storey?

[Bling Keeta]

Bruce, it only happens with this particular file.
Other files working normally.
Thanks.

[Bruce]

Then I would say what most likely has happened, is there is an element widely scattered from the rest of your model. If, at full extent, you do a select all, you may notice two different groups of hotspots. This should enable you to identify which element/s have gone rogue...

[Bling Keeta]

I suspect this is the problem too. But Select All does not show anything.
By the way , Elevation and Section windows work fine.

[Bling Keeta]

I finally found that little dot far away from the building. Problem solved. Thanks.