Hi Everyone, i'm back again with yet another bug (i'll start numbering them from now on i guess)
I was trying to create a terrain model using mesh and adding contour lines onto it by using magic wand (specifically on the contour lines, not in between the lines).
The problems are:
1. in AC22 whenever i add new ridges using magic wand, it always create two ridge lines at the same time even if i only highlight one line at a time.
2. one or both of resulting ridge lines would then be a discontinued ridge line.
3. it makes modeling a terrain with a lot of contour lines (hundreds) even harder to work with
I tried using the same dwg file, same method, no difference whatsoever in AC21, and it worked just as it should, no problem whatsoever (I've been working using this method without any problem whatsoever since AC15)
any clue on how to fix this would be greatly appreciated, thanks in advance
-John
