CURVED SECTIONS

[Anonymous]

Maybe this is dump question but is it possible to make curved section in archicad 12

[Anonymous]

I'm afraid not. Curved sections are not even available in AC13. You could try creating several short individual sections and join them back together on a layout. It's not really curved, but it's the best we can do.

[Gerald Hoffman]

You can make a curved 3D section view but I think you are looking for a 2D section cut.

[Eduardo Rolon]

If you can see it in the 3D window you can save it as a 3D Document. The only thing to configure is the 3D View Settings to see the model in elevation.

[Anonymous]

How did you to the 3d curved section?

[Anonymous]

I knew for this 3d curved secion, but I was looking for 2d section plan... Never mind, I'll try with several shorter sections and with matching them. Anyway thanks for helping...

[Dwight]

Profoxcg wrote:
How did you to the 3d curved section?

A circular marquee is made by magic wanding a circle.

[Anonymous]

😉 sounds good thanks

[Dwight]

In fact, even a magic wanded marquee will follow even a negative/void edge in Archicad 13, where some prior editions did a shortcut.