HEELP!! custom curved ramp
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-08-30
08:18 AM
- last edited on
2023-05-25
05:05 PM
by
Rubia Torres
2010-08-30
08:18 AM
i know archicad has a curved ramp tool but it only lets you follow a circular path not a custom one.
of course you can create a custom curved path as i have done using spline and then slab or mesh tool but this is not a ramp until one end is higher than the other.
I basically want this ramp to go from say 0 - 6 metres high at a uniform gradient.
i have tried objective (much of my hair was pulled out trying to get it to do what i wanted) but my conclusion is that the 'regular profile' does not, will not and never has any intention of following a 'defined' path you give it... only the path that regular profile wants to follow.
i could raise every randomly spaced mesh point individually calculating how high to raise each point each time... this would take 78,000 light years and i have only 2 days to figure it out.
any help is greatly greatly appreciated!!

21 REPLIES 21

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-08-31 09:41 PM
2010-08-31
09:41 PM
Just add the unpacked folder into your current project using the Library manager and it should work.
Running ArchiCAD 23 INT.
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2010-08-31 09:47 PM
2010-08-31
09:47 PM
I finally got it! I had to double click in winrar. Then extract the subfolders.
Thanks again!
Thanks again!
- « Previous
- Next »
- « Previous
- Next »