How to draw a wall

[Anonymous]

hi, newish user of archicad, use mainly autocad..

anyhow, please could anyone tell me of how to draw a wall wich say starts at 1m high and then gradually inclines to 3m over the distance of say 6m?

i basicly want a wall that starts lower and inclines, have tried to find a way but i have a deadline coming up and so running out of time to find out for myself!!

please help!?

[Anonymous]

joeish wrote:
hi, newish user of archicad, use mainly autocad..

anyhow, please could anyone tell me of how to draw a wall wich say starts at 1m high and then gradually inclines to 3m over the distance of say 6m?

i basicly want a wall that starts lower and inclines, have tried to find a way but i have a deadline coming up and so running out of time to find out for myself!!

please help!?

can you post some pic want you want...just sketch it with lines and i will help you.

[Anonymous]

the side wall of the building i have drawn and attached, is what i need to draw, it is higher at the front of the building and then lower to the rear.

thanks so much,

cheers Joe

[Anonymous]

here is the drawing again without the roof on 🙂

[Anonymous]

soemthing like this ????

[Anonymous]

yeah thats the thing i mean 🙂

[Dwight]

Use the roof element to trim it.

See: "Trim Element to roof"

In USA manual, this is page 736

You draw the wall to full height and use the roof over as the trimer.

[Dwight]

Use the roof element to trim it.

See: "Trim Element to roof"

In USA manual, this is page 736

You draw the wall to full height and use the roof over as the trimer.

[Anonymous]

is there a way if there was no roof?

just to have the wall?

[Dwight]

Try discarding the roof after the trim.