Section problem

[Anonymous]

Why is that the beam in a section goes behind the wall? When I make "Bring to front" it always stays behind. Anyone knows why?

[Anonymous]

Ruben wrote:
Why is that the beam in a section goes behind the wall? When I make "Bring to front" it always stays behind. Anyone knows why?

Beams have priorities like walls do. Make it higher than the corresponding wall has.

[Thomas Holm]

"Bring to front" only affects 2D floor plan display, not sections.

Sections are essentially special parallel 3D views rendered with the Internal engine. If the beam is hidden by a wall and you want to see it, place the wall on a hidden layer or make the wall transparent or simply move the wall or beam so the beam can be seen.