Setting origin of vectorial hatching?

[Anonymous]

I have used tiles 200 x 200 in a bathroom, with vectorial hatching tiles 200 x 200.

When I make a section, and open the section, I see that the origin of the vectorial hatching is a different place than where I want it. Is there a way I can set the origin of where the hatching should begin?

[Mats_Knutsson]

ju§titia wrote:
I have used tiles 200 x 200 in a bathroom, with vectorial hatching tiles 200 x 200.

When I make a section, and open the section, I see that the origin of the vectorial hatching is a different place than where I want it. Is there a way I can set the origin of where the hatching should begin?

Hi,
http://www.graphisoft.se/Support/tips_tricks/Filmer/Bestamma_isattningpunkt_for_textur_Align_3D%20_e...

It's in swedish but it's ok for you I guess...😉

Cheers,
Mats