Sloping Profiler
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2006-01-31 03:25 AM
Thanks, as usual.
Scott
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-08-31 10:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 04:53 PM
I've followed your instructions and have gotten the detail looking decent except for one thing. Please see the attached images. The sloping profile cuts well but when I use a slab to cut the eave profile it doesn't get the correct angle. I believe it not only needs to be cut at a 45 but the edge of the slab also needs to have an angle to get it to clean up correctly? Is this what you did in your instructions? Thanks and sorry, this is my first try at attempting to fully detail a building and there have been a few kinks on my part.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 04:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:06 PM
The cuts must be plumb cuts so the slab edges
must be perpendicular ie vertical.
Peter Devlin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:25 PM
The cut on the right member appears to be correct.
The cut on the left is not correct. Could you show us
a top down view of these two pieces ?
Thanks,
Peter Devlin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 09:39 PM
Why is the left member wider then the right member.
The plan width should be the same. Also, your image
seems to be a perspective. Could we have an orthogonal top view ?
Thanks,
Peter Devlin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-09-06 10:00 PM