Terrain not showing solid body

[Anonymous]

Hi. I´m encountering some problems with a terrain model i´ve created. The terrain doesn´t show the solid body.

Initially I made the mistake of setting the terrain mesh height too low, so when i put inn the z-values of each height curve the mesh went below the mesh height.
This resulted in the terrain not showing the solid body in neither section, facade or 3D view.
I then changed the mesh height after completing the z-values of the curves, to make sure the height has a lower z-value than any point on the mesh surface.
Problem is, the terrain still doesn´t show the solid body of the terrain. I am positive that the mesh height is now under the height of all z-values of the mesh curves.

Can someone tell me how to get solid body for the terrain, or is my only option to make a new terrain from the curves?

Regards Jon

[Anonymous]

Here is an image attachment showing the terrain.

[Anonymous]

jonbech wrote:
Hi. I´m encountering some problems with a terrain model i´ve created. The terrain doesn´t show the solid body.

Initially I made the mistake of setting the terrain mesh height too low, so when i put inn the z-values of each height curve the mesh went below the mesh height.
This resulted in the terrain not showing the solid body in neither section, facade or 3D view.
I then changed the mesh height after completing the z-values of the curves, to make sure the height has a lower z-value than any point on the mesh surface.
Problem is, the terrain still doesn´t show the solid body of the terrain. I am positive that the mesh height is now under the height of all z-values of the mesh curves.

Can someone tell me how to get solid body for the terrain, or is my only option to make a new terrain from the curves?

Regards Jon

mesh tool needs a revamp. it's antiquated

[adura]

Hi jonbech,

Change "bottom elevation value" of your mesh. Make it too low value, try different values until it seems.

Good luck 🙂