Trimmed door openings?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2005-05-18
04:19 AM
- last edited on
‎2023-05-25
06:20 PM
by
Rubia Torres
‎2005-05-18
04:19 AM
"Bob" - Church of the Sub-Genius
Graphisoft afficionado since 1993
Graphisoft afficionado since 1993
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2005-05-18 05:07 AM
‎2005-05-18
05:07 AM
lagodue wrote:yes - use a simple door - either D1 wood or metal - and turn the leaf off in the settings, make the frame non-existent, etc . . . and then turn on trims.
Is there any way to create an empty opening (no door) that has the same trim (casing) as a door?
HTH
~/archiben
b e n _ f r o s t
b f [a t ] p l a n b a r c h i t e c t u r e [d o t] n z
archicad | sketchup | morpholio | phpp
b f [a t ] p l a n b a r c h i t e c t u r e [d o t] n z
archicad | sketchup | morpholio | phpp
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2005-05-18 04:37 PM
‎2005-05-18
04:37 PM
OK
tried this, but no joy. i set panel thickness to zero (there is no on/off button for the door panel) and door still appears as a single line plane. any additional input would help.
Thx
tried this, but no joy. i set panel thickness to zero (there is no on/off button for the door panel) and door still appears as a single line plane. any additional input would help.
Thx
"Bob" - Church of the Sub-Genius
Graphisoft afficionado since 1993
Graphisoft afficionado since 1993
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2005-05-18 04:45 PM
‎2005-05-18
04:45 PM
disregard previous message - solution is to select "empty" for panel type.
"Bob" - Church of the Sub-Genius
Graphisoft afficionado since 1993
Graphisoft afficionado since 1993
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2005-05-19 02:25 AM
‎2005-05-19
02:25 AM
lagodue wrote:that's what i meant by turning the leaf 'off' in the settings
disregard previous message - solution is to select "empty" for panel type.

cheers
~/archiben
b e n _ f r o s t
b f [a t ] p l a n b a r c h i t e c t u r e [d o t] n z
archicad | sketchup | morpholio | phpp
b f [a t ] p l a n b a r c h i t e c t u r e [d o t] n z
archicad | sketchup | morpholio | phpp