Wall slant

[Anonymous]

I would like to taper a curved wall from top to bottom in Archicad 15. This would be similar to an inverted cone surface unwraped to an arc. Thanks.

[Dwight]

Without being a workaround apologist or anything, for now, use a curved ramp to trim the wall with a Solid Element Operation.

[Anonymous]

Thanks for the info. I didn't explain myself very well. I would like to taper the sides of a wall. Not the top like a ramp. The top of the wall would be the original width and the bottom of the wall would taper inwards creating a narrower footprint than the original. I'll try to use a roof element on each side and trim to the bottom and see if that works. Thanks again.

[Eduardo Rolon]

Is this what you are looking for?

[Eduardo Rolon]

Curve example 01

[Eduardo Rolon]

Curve example 02

[Eduardo Rolon]

or with a custom profile