alignment-drag beam

[Anonymous]

Hello,
I need to move the beam from center to the center of a colum, but can not find the mid point of the beam which can drag to the center of a colum,
is there any way similar to Revit auto alignment?
Thanks

[Barry Kelly]

If you have your 'Snap Points' turned on and set to 'Half', then when you touch an edge of the beam in section you will get a half snap point.
Now you can drag from there to where ever you want.

You could also use the 'Align' tool (Special align - centre note with draw line arc).
But I don't think this is as good as it is not really intended to be used in this situation.


Barry.