cant find my model in 3d?

[Anonymous]

In parallel I can see my model fine, but when I switch over to perspective it disappears and I cant find it anywhere.. iv tried zooming about in and out, panning about and “zoom fit in window” and nothing.
Is there a way I can center it back to the middle of the screen again?

[Anonymous]

all sorted.

[Djordje]

What was the problem?

[Anonymous]

On ground floor use a camera and then go to 3d from navigator by selecting the camera you made.

[Anonymous]

Djordje wrote:
What was the problem?

not sure what it was.. nothign would find it.. i started randomly clicking and changing number in teh perspective settings and finaly a small corner of the modles showed up.. then i had to work out how to get it back in the center.. once i did, zoom and rotate all started working fine.. was very wierd

[rocorona]

There are two magic click, to bring back a disappeared the "cone of view" in the perspective setting preview:
Shift-Click --> Point of view
ALT-Click --> Target

[Anonymous]

Universe is BIG! 😉

[Anonymous]

rocorona wrote:
There are two magic click, to bring back a disappeared the "cone of view" in the perspective setting preview:
Shift-Click --> Point of view
ALT-Click --> Target

nice.. ill write these down
thanks

[Djordje]

rocorona wrote:
There are two magic click, to bring back a disappeared the "cone of view" in the perspective setting preview:
Shift-Click --> Point of view
ALT-Click --> Target

CTRL-click camera