Graphisoft Community

Mariano_BAMA · 2021-11-24

Hi Everyone,I checked same of the existing conversations in and around window corner. It seems to me, that it is not possible yet to hendle the two section of a corner window seperately. I meant, they cannot be customazie individually. is it correct?...

Mariano_BAMA · 2021-09-02

Hi All,I have imported, as xref, a DWG file, and I set in a worksheet document.I need to manipulate the file and I noticed that all the dimensions are not scalable. I mean they remain as they would be in a paper space and not in the model.The consequ...

Mariano_BAMA · 2021-11-30

Thanks Lingwisyer, to your participation and comment  

Mariano_BAMA · 2021-11-30

Thanks Barry, for your advise. I will use it next time.Ps. Sorry to reply you so late.Thanks again. 

Mariano_BAMA · 2021-11-24

Ps. I hope in the next version of Archicad they will allow to manipulate separately each section of the corner window. It makes more sense.Thanks again

Mariano_BAMA · 2021-09-08

Thanks DGSketcher, good advice.

Mariano_BAMA · 2021-09-06

Hi Eduardo,thanks for your reply, I will try to apply your solution and I let you know. However and for what I understood, using your approach I cannot locate the file on ITM - Irish Transverse Mercator - Coordinates, which is no more no less the Iri...

Graphisoft Community

User Statistics

User activity

Corner window

Dimensions from DWG drawings

Re: Corner window

Re: Corner window

Re: Corner window

Re: Dimensions from DWG drawings

Re: Dimensions from DWG drawings