....and the line is more than 6m long... ....and the more lines you
select.... .....and the scale you are at and... ..........and i give up
on investigating, quicker to just convert them to lines. using edit ->
Reshape -> Linework Consolidation tool....
For a line more than 6 meters long, For the Adjust command, the start
point is kept for polylines, unless there are start points on for
multiple selected polylines on both sides, then the oldest drawn line
starting side is kept. It appears the lines ...
Yes the part of the wall that has the cavity slider door in it would
need to be a complex Profile Remember to connect the stud fill and the
cavity fill when using modifiers or only the fill connected will change
when using the modifier
https://helpce...
I assume that you are using different Zone Categories for apartment
units so: add an integer property and add the expression: IF (
{Property:Zone/Zone Category} = "1 BED", 1, IF ( {Property:Zone/Zone
Category} = "2 BED", 2, IF ( {Property:Zone/Zone C...
FYI, on a PC the standard is: CTRL + D for Drag, when in Drag mode...
tap the CTRL key turns it into Drag a Copy, tap the CTRL key again it
changes back to Drag. tap the ALT key turns it into Drag Multiple
Copies, tap the ALT key again it changes bac...
