Publishing Bim x fails

[Rikus Engelbrecht]

Hi I am having issues publishing a Bim-x model. It fails every-time. I see similar issues have been experienced by others, but I see no solution to the problem. Can anyone help? 

[Barry Kelly]

There should be a yellow (or red?) warning triangle in the publisher window when it fails.

You can double click it to get information I think.

One thing I would check is that you are not using unusual characters in the file name you are publishing (?~/| etc.).

Keep the name a simple as possible.

Barry.

[Rikus Engelbrecht]

Hi Barry, 

Thanks I checked that message and this is what I get. 

As you can see the file name is also quite simple. 

[Barry Kelly]

What do you have in your publisher set.

This will also show me the name you have used.

i.e.

If you create a new publisher set with maybe just a wall or two, will that publish?

Is the path to save the BIMx file correct (i.e. it does exist and you have permission to save there)?

Barry.

[Rikus Engelbrecht]

Hi Barry, 

Please see attached screenshot. 

Tried exporting to desktop. 

 

[Rikus Engelbrecht]

Ok, so I tried publishing a single wall, that worked. This means there is probably an element in the 3D that is causing this issue? 

 I have however down-saved the file to a 25 and published on another workstation without any issues. 

[Barry Kelly]

Settings all look OK.

I would suspect something in the model.

Maybe try turning all layers off and just turn a few on at a time to try and isolate where the problem may be.

Barry.