Complex profile section through window without lines

[Anonymous]

Hello everyone, this is my first post here, I have not been able to find that someone wrote about this problem.

When a section is made through a window in a wall that is made as a complex profile, no lines are displayed above and below the window.



Does anyone have a solution to this problem, and if not, that bug should be repaired.

[Barry Kelly]

In the Profile Manager, select the fills used in the composite and be sure that you have 'Show Cut End Lines' active.

Barry.

[Anonymous]

Thanks! I don't know how I didn't see that.

There is another issue. How to change wall closure on windows upper side? I know how to change left and right side, but can't find for upper side.

Maybe I should make another topic for this question?

[Lingwisyer]

Within your section? You cannot. It is a limitation of the software... Sections are generated from the 3D script of which there is not scripting for a top or bottom closure, while the for the plan, it is scripted in the 2D script.



Ling.

[Anonymous]

Ok, thanks! Maybe it should be considered for future versions of models.

[Laszlo Nagy]

Lingwisyer wrote:
Within your section? You cannot. It is a limitation of the software... Sections are generated from the 3D script of which there is not scripting for a top or bottom closure, while the for the plan, it is scripted in the 2D script.

Ling.

So, it is actually not a limitation of the software, because ARCHICAD could do it.
It is the limitation of the Library Part, which is not generating Reveals in 3D, only 2D.

[Lingwisyer]

Well, a limitation of most, if not all, of the default library parts.