The fundamental code is still made with the Polygone-Code from VinceV6.
To put in such an opening correctly - You have to use the following workflow:
1. In the normal Library-Part dialog-box - make it so wide as You want it at last. This is, because the polygone is completely septerated from the normal opening measures. Later alterings of the with will scrample the design.
2. in the dialoge - put on the sight in groundfloor (in german dialog:"2D aufriss einschalten").
3. Design Your form in groundfloor or also in 3D - the contour-polygon and also the devidings from the 2 additional editable hotspots slightly out of the corners - to draw in the deviding - profiles.
4. Tor change the angle of the inserted profiles - do this in groundfloor first. Once the angle of the profile is changed, its possible to do this also in 3D - but not before and not, if You put it back to 0.
Tell me here what You think of it.
A English video is in upload and will follow here in some hours.
Now i got it finally!! It sometimes (very often) - is very hard to understand the GDL-handbook - because it is so poor in examples. The textal description is right - but very without an minimal amount of examples)
You have to repeat the valuename once again instead of displayParam! - thats all!
Why dont they tell this clear! It is written there in a way - my simple mind could not understand it for hours! I had to find out with trial and error - seeking!