Door leaf does not match door size

Patrick M · a week ago

whats the deal? door is set to 2'-6". Door opening is 2'-8", door leaf is 2'-4"... I have a 1" gap between my door and the frame. I'm not seeing any setting to undersize the door to the frame. anyone run into this before?

Operating system used: Mac Apple Silicon

BIM solutions and trouble shooting (self proclaimed) expert. Using Archicad Version (all of them), on Mac OS (whatever is 1 version older than current)

Lingwisyer · a week ago

What does the frame tab show?

AC22-29 AUS 3200	Help Those Help You - Add a Signature
Self-taught, bend it till it breaks	Creating a Thread
Win11 \| i9 10850K \| 64GB \| RX6600	Win11 \| 7800X3D \| 32GB \| RTX5070TI

Patrick M · a week ago

nothing out of the ordinary... I just rebuilt them from out of the box defaults... just a weird glitch, injecting one door type into another

BIM solutions and trouble shooting (self proclaimed) expert. Using Archicad Version (all of them), on Mac OS (whatever is 1 version older than current)

Lingwisyer · a week ago

Injecting settings can give odd results if the source and host do not have identical parameters (not values). I swapped one of my custom sliders which was based GS macros into a GS slider (libpacks broke my custom one...) and the panels when set to fully closed only covered half the opening...

AC22-29 AUS 3200	Help Those Help You - Add a Signature
Self-taught, bend it till it breaks	Creating a Thread
Win11 \| i9 10850K \| 64GB \| RX6600	Win11 \| 7800X3D \| 32GB \| RTX5070TI

Door leaf does not match door size

Didn't find the answer?

Check other topics in this Forum

Read the latest accepted solutions!

Start a new conversation!