I was thinking about something like in the scheme below.
I could maybe tie the cut plane position to an editable hotspot and drag it where I want. But then I'm not sure how to make the cut planes effective only for the 2D projection of the object. In 3D, the whole object should be visible at all times.
(note: this is just to illustrate the GDL object content, not that I want the actual cut plane in 3D)
This will need to be scripted. You can use something like the following for the options you chose to display:
if GLOB_CH_STORY_DIST = 0 then
'do something' !! Home story
if GLOB_CH_STORY_DIST = 1 then
'do something else' !! One story up
if GLOB_CH_STORY_DIST = -1 then
'do something else again' !! One story down
AC 19 6006 & AC 20
Mac OS 10.11.5
15" Retina MacBook Pro 2.6
27" iMac Retina 5K