cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
EN
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Anonymous
Not applicable

‎2005-02-06 03:26 PM - last edited on ‎2023-05-26 11:44 AM by Graphisoft

sliding door D1 Pocket

‎2005-02-06 03:26 PM
I tried unsuccessfully to change the fill ( in 2D)of the sliding door D1 Pocket of the AC Library. Usually its easy to change the fills/colors of an door, objects etc. in settings/parameter/ 2D Representation. But at this door its not possible. How can I change it ?

Jens
Labels:
0 Likes
1 Reply 1
Anonymous
Not applicable

‎2005-02-09 06:26 AM

‎2005-02-09 06:26 AM
Jens - I believe that there is currently no way to fix this fill on standard parts - I had hoped that this condition would be fixed with an update - but no luck so far. The usual way is to edit the GDL code of the door leaf, removing the fill. I searched and could not find where the offending fill was written.

I know this doesn't help - perhaps someone smarter than I could figure it out.

Lew Bishop
AC9/ P4-2.53 nVidea 440 XPPro
0 Likes

Didn't find the answer?

Check other topics in this Forum

Back to Forum

Read the latest accepted solutions!

Accepted Solutions

Start a new conversation!

Create new topic